Case International B Series B250 Electrical PARTS
Agriline Products Ltd stock a range of electrical tractor spare parts from many high quality manufacturers to suit Case International B250 tractors. In addition to this, Agriline also stock Lucas, MAHLE, Cobo and Lucas TVS parts. This includes Switches, Wiring, Starter Motors, Dynamos, Alternators, Gauges, Sensors, Tachometers, Lights, Bulbs and much more.
Ignition Switches
-
Premium Ignition Switch, Heat and start suitable for Case International - 3048227R92 Premium Quality ignition switch,Heat and start, 4 terminals.£21.60 Inc VAT £18.00 Exc VATOut of stockPart No.74911
Wiring Looms
-
Wiring Harness suitable for Case International - Suitable for models with lever type starter motor.£41.99 Inc VAT £34.99 Exc VATIn stockPart No.5018
Starter Motors
-
Starter Motor suitable for Case International - Lucas M45 Type.
12V.
2.2 kW.
LH Fit.
Fitting: 3 Hole.
Flange RH Opening.
Teeth: 10.
£118.80 Inc VAT £99.00 Exc VATIn stockPart No.8021 -
Starter Motor suitable for Case International - 704447R94 Early IHC Lever Type (1958 - 1964)Supplied With Rubber Boot Which Sits Over The Top Of The Lever.£178.80 Inc VAT £149.00 Exc VATOut of stockPart No.8153
Dynamos
-
Tractor Dynamo suitable for Case International - 3049871R91 K908882
These 12V dynamo are a direct replacement for the Original Lucas C40 dynamo, with a single spade on the rear and a lug on the side.
These dynamos have been redeveloped to be fully weather proof; the positi... Show More
£66.00 Inc VAT £55.00 Exc VATIn stockPart No.5297 -
Dynamo - Spade Terminal on Rear suitable for Case International - 3049871R91 K908882 Dynamo - Spade Terminal on Rear£66.00 Inc VAT £55.00 Exc VATOut of stockPart No.5297A
Heater Plug
-
Glow Plug - 710348R1 suitable for Case International - 710348R1Glow PlugDimensionsThread: No.18 BS Spark Plug. 18mm x 1.5 PitchNote that these must be wired in series£15.00 Inc VAT £12.50 Exc VATIn stockPart No.5721
Solenoid
-
Starter Solenoid suitable for Case International - Genuine Lucas.£21.59 Inc VAT £17.99 Exc VATIn stockPart No.9029
-
Solenoid suitable for Case International - 12V SolenoidMounting Centers: 40mm£11.99 Inc VAT £9.99 Exc VATIn stockPart No.5171
Condensor
Contact Sets
Rotor Arms
Gauges
-
Water Temp Gauge suitable for Case International - Water temp gaugeDimensions- Body OD: 52mm- Bezel OD: 57mm- Wire Length: 190cm- Sender Thread OD: 15.3mm&... Show More£18.00 Inc VAT £15.00 Exc VATIn stockPart No.5055
Headlight Spares
-
Bulb 12V 5W BA15D SBC G18.5- Single suitable for Case International - Side/Indicator bulb ECC Approved.£0.42 Inc VAT £0.35 Exc VATIn stockPart No.9365
-
Bulb 12V 5W BA15D SBC G18.5- Box 10 suitable for Case International - Side/Indicator bulb ECC Approved.£3.60 Inc VAT £3.00 Exc VATIn stockPart No.9365A
Side Lamps
-
Butler Side Light suitable for Case International - Models With Round Fenders.
Supplied With Bulb.£15.00 Inc VAT £12.50 Exc VATIn stockPart No.5029
Beacons
-
Rotating Warning Beacon suitable for Case International - For Negative Earth Tractors
Fixed Pin Fitting.
Pin Fitting : 24mm.
Overall Height: 60mm.
Diameter: 125mm.
12V H1 Halogen Bulb.12V / 55W , 24V / 70W.
Impact Resistant Lens.
CE Approved.
Replacement Bulb - Agriline Ref: 9368<... Show More£25.98 Inc VAT £21.65 Exc VATIn stockPart No.54028Beacon Bracket suitable for Case International - Supplied with weather rubber cap for when beacon not in place.
Anodised plating for weather resistance.
Pin Height: 100mm.
Fixing Slots: 11mm x 22mm,
Fixing Slots Centre to Centre: 80mm.
£9.35 Inc VAT £7.79 Exc VATIn stockPart No.8452Beacon Bracket suitable for Case International - Supplied with weather rubber cap for when beacon not in place.
Anodised plating for weather resistance.
Pin Height: 95mm.
Fixing Hole : 8mm
Fixing Holes Centre to Centre: 38mm.£9.35 Inc VAT £7.79 Exc VATIn stockPart No.8450Rotating Warning Beacon suitable for Case International - Flexible Stem.
Pin Fitting : 24mm.
Overall Height: 315mm.
Diameter: 127mm.
12V H1 Halogen Bulb.
Impact Resistant Lens.
Operating Temperature -30° to 50°.
E Approved.
Replacement Bulb - Agriline Ref: 9368Currently unavailablePart No.A-186Beacon Bracket suitable for Case International - Supplied with weather rubber cap for when beacon not in place.
Anodised plating for weather resistance.
Pin Height: 100mm.
Fixing Slots: 11mm x 22mm,
Fixing Slots Centre to Centre: 55mm.
£8.39 Inc VAT £6.99 Exc VATIn stockPart No.8451